Mechanical inspection

1. Check whether the safety device is firm, whether the screws and nuts of each part are loose, and whether the fuel leaks. In particular, whether the mounting screws of the blade and the screws of the gearbox are fastened, and if they are loose, they should be tightened.

2. Check whether there are wires, stones, metal objects and other sundries that hinder the work in the work area.

3. Check the blade for nicks, cracks, bending, etc. Whether there is any abnormal noise, if so, check whether the blade is clamped properly.

4. Be sure to keep the brushcutter off the ground or an obstacle when starting.

5. When starting the engine, make sure that there are no stray people around. Make sure the blade is off the ground before restarting.

6. When the temperature is low, the choke door should be opened, and the choke door is not required when the car is warmed up.

7. Slowly pull out the start rope until it stops, and then pull it out quickly and forcefully after it bounces back.

8. When there is no load, the accelerator should be pulled to the idle speed or small accelerator position to prevent the phenomenon of speeding; the accelerator should be large when working.

9. Do not start the engine indoors.